Propeller Solutions
Propeller Solutions

Propeller Solutions

Your propeller is a key factor in your boat’s performance, and your satisfaction; so don’t overlook it. Maintain it for peak power, performance and efficiency. Consult YamahaOutboards.com/Propellers or your authorized Yamaha Marine dealer for more information.

It’s all in the eyes.

Give your prop a good look as part of your pre-launch checklist. Are there any bends, nicks, cuts or cracks? Any of these will rob performance and potentially cause damaging vibration to your outboard. If found, get the prop examined and repaired by a qualified propeller repair facility. Your local Yamaha Marine dealer is a great place to start.

Something missing?

If you’ve noticed a decrease in your boat’s performance, but your outboard checks out fine, you’d do well to suspect your prop. Suspended grit, sand and away at your propeller’s edges. When this happens, your prop may look perfect, but the worn edges can seriously degrade performance.

Beware corrosion.

Even stainless steel props can experience surface discoloration. But it’s easy to clean and protect most props. Try these simple tips:

  • Rough Cast Mag Wheel Cleaner. Spray on (use caution near painted surfaces), do not let dry or sit more than 30 seconds, agitate with dish sponge, rinse thoroughly, dry, apply paste wax.
  • Toilet Bowl Cleaner, Hydrogen Peroxide, or Calcium Lime & Rust Remover. For spot cleaning: spray on or put on a rag and wipe over stained area (do not allow to dry). Rinse thoroughly, dry, and follow up with paste wax.
  • Mild Rubbing Compound or Metal Polishing Paste. For difficult stains: apply to pad and rub in a circular motion until stain is diminished. Buff with a clean cloth, apply paste wax.

Steve Pennaz on propellers

Cleaning Your Propeller, Pt. 1

Cleaning Your Propeller, Pt. 2

Cleaning Your Propeller, Pt. 3

Protect the propshaft.

Periodically remove your propeller(s), check for fishing line wrapped around the prop shaft, then grease the prop shaft with a high-quality, high-pressure marine-formula grease like Yamalube® Marine Grease or Molybdenum Grease. This will help make it easier to get the prop off next time, especially in saltwater. When re-installing your propeller, make sure to torque the prop nut to the manufacturer’s specification, and always use a new cotter pin rather than re-using the old one.

Be prepared. 

Just like a spare tire, you may need more than one prop. Whether you demand different levels of performance or just want a spare for emergencies; having a second propeller is a very wise choice.

©2015 Yamaha Motor Corporation, U.S.A. All rights reserved. Anglers are paid endorsers.
Remember to always observe all applicable boating laws. Never drink and drive.
Dress properly with a USCG-approved personal floatation device and protective gear.